Avitech Rainier-4d Manuel d'utilisateur télécharger pdf (Page 15)

Proprietary RJ-45 to RS-232 (DB9-FM) Cable

(optional – refer to the “NOTE” below.)

Ear with screw (already installed on Rainier 3G upon

order for assembly on to rack mount)

* This is an optional external power supply along with the associated dual power supply PCBA

inside the Rainier 3G to achieve power redundancy. If this optional external power supply is

connected power (AC or DC) can be unplugged on the Rainier 3G without affecting the power

supply to the unit.

** When using the DVI-I female connector on the Rainier 3G the connector may easily be

damaged if the DVI-I plug (male) has bended pins. With this optional DVI-I male-to-female cable

permanently connected to the Rainier 3G frequent connection and disconnection will only occur to

the female end of this short cable, rather than to the female connector of the Rainier 3G.

*** The Avitech TACP can be used with the Rainier 3G. Contact your authorized dealer or refer to

the TACP User Manual for more details.

NOTE: Due to space limitation the serial connector is replaced with a RJ-45 connector. A

proprietary RJ-45 to RS-232 (DB9-FM) cable is needed for serial function. The pin

definition is shown next.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 186 187

Pas de commentaire

Avitech Rainier-4d Manuel d'utilisateur Page 15